Publicidad
Idiomas disponibles
Idiomas disponibles
9
Installing the sink
□
Apply silicone sealant (not included) around the underside and lip of the sink (A).
□
Carefully lower the sink (A) into the counter.
□
Attach the mounting clips (AA).
□
with the counter. Do not overtighten.
□
Wipe excess sealant with a rag.
11
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
□
Pull the hose assembly out of the spout and
remove the spray head by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into the
sink and turn the faucet to the warm position
where it mixes hot and cold water.
□
away any debris that could cause damage to
internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the spray head by hand
tightening it back onto the spray hose in a
clockwise direction.
10
Making the water supply connections
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting tubes together or placing the tubes close to each
other and damaging.
□
Thread the nut (1) on the supply line onto the
outlet of the water supply valve (2) and tighten
with a wrench. Do not overtighten.
1
2
12
Removing the quick connector
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
2
Squeeze
1
Pull
down
1
HOMEDEPOT.COM/GLACIERBAY
Publicidad
