Технические Характеристики - YI Dome U Camera Pro Manual De Instrucciones

7. Технические характеристики
Максимальное разрешение: 2304×1296
Объектив: шикороугольный
Аудио: встроенный микрофон/динамик
Фотографическое улучшение: 3D цифровое
шумоподавление
Wi-Fi: 802. 11b/g/n, 2.4 G Hz
Режим оповещения: улучшенное обнаружение
движения, обнаружение человека
Ночное видение: ИК-фильтр + инфракрасные светодиоды
Поддерживаемые платформы: Android, iOS, Mac и PC
Беспроводное шифрование: WEP/WPA/WPA2
Длина кабеля USB: 2 метра
Питание: DC 5V / 1A
Потребляемая мощность: 5 Вт (макс.)
Поворот/наклон: 350 ° по горизонтали, н
аклон по вертикали вверх на 53 °,
наклон по вертикали вниз на 10 °
Хранение данных: MicroSD карта памяти и облачное
хранилище YI Cloud
Диапазон рабочих температур: от -10° до 50°С по Цельсию
60
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
The distance between user and products should be no less than 20cm
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However , there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver .
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
61