Publicidad
Honda NC700X and Varadero XL1000V handlebar weight removal
Remove original handlebar end weight with internal weight parts.
Left side roll back hand grip and depress the two retaining clips through
the holes in the handlebar with a screwdriver. There is one top and one
bottom. On right side remove throttle twist grip. Leave handlebar weight
connected to the internal weight to help with removing the internal parts.
Pull on weight while pressing clips through hole. See pictures to right.
15
1
18
9
15
1
11
9
INS-BHG46.2-NP
Honda NC700X Handguard Installation
LEFT SIDE
LEFT SIDE - NC700X
NC700X
5
13
12
14
11
Honda XL1000V Varadero Handguard Installation
LEFT SIDE - Varadero 1000
LEFT SIDE
Varadero
5
13
12
14
RIGHT SIDE - NC700X
7
3
13
12
14
8
2
6
6
Installation is shown for the left side. Repeat for right
7
side with applicable parts.
Loosely assemble the clamp to the handlebar with clamp
4
connector (4).
Attach the handguard backbone with
applicable parts to the handlebar end. Attach inner end of
backbone to handlebar clamp connector.
backbone in preferred position and tighten all bolts in the
following order: (7), (6), (5) then (9). Important: Use the
8
specified torque setting on front page.
2
6
6
16
1
17
9
Position
Removed weight parts
Loosely assemble the clamp to
the
handlebar
with
clamp
connector
(3).
Attach
the
handguard
backbone
with
applicable parts to the handlebar
end.
Attach inner end of
backbone to handlebar clamp
connector. Position backbone in
preferred position and tighten all
bolts in the following order: (7),
(6), (5) then (9). Important: Use
the specified torque setting on
front page.
Manufactured by:
Publicidad
