Publicidad
Honda Crosstourer VFR1200X Installation
15
9
Installation is shown for the left side. Repeat for right side with applicable parts.
Loosely assemble the clamp to the handlebar with clamp connector (3). Remove
original handguards and handlebar end bolt. Attach handguard backbone with
original weight/expander, internal nut and applicable parts. Attach inner end of
backbone to handlebar clamp connector. Set backbone in preferred position and
tighten all bolts in the following order: (7), (6), (5) then (9). Important: Use the
specified torque setting on front page.
Remove original handlebar end weight with internal weight parts.
Undo screw in weight about three turns, tap screw head in to free up. Pull weight
out while using an up and down movement to remove the complete assembly.
Installation is shown for the left side. Repeat for right side with applicable parts.
Loosely assemble the clamp to the handlebar with the clamp connecting part (3).
Attach the handguard backbone with applicable parts to the handlebar end. Attach
inner end of backbone to handlebar clamp connector.
preferred position and tighten all bolts in the following order: (7), (6), (5) then (9).
Important: Use the specified torque setting on front page.
INS-BHG46.2-NP
LEFT SIDE
LEFT SIDE - Crosstourer
Crosstourer
3
5
6
Suzuki V-Strom DL650/1000 Installation
Position backbone in
Kawasaki Versys 1000 Installation
7
15
8
2
10
6
Installation is shown for the left side. Repeat for right side with applicable parts.
Loosely assemble the clamp to the handlebar with clamp connector (3). Attach the
handguard backbone with applicable parts to the handlebar end. Attach inner end
of backbone to handlebar clamp connector.
position and tighten all bolts in the following order: (7), (6), (5) then (10).
Important: Use the specified torque setting on front page.
15
9
LEFT SIDE - Versys 1000
1
Position backbone in preferred
LEFT SIDE - V-Strom
13
1
12
11
14
LEFT SIDE
7
Versys 1000
3
5
8
2
6
6
LEFT SIDE
7
V-Strom
3
5
8
2
6
6
Publicidad
