3M TARTAN HB-933 Funcionamiento

H-2960
3M HB-933 TARTAN™
®
PISTOL GRIP DISPENSER
LOADING
1. Pull back spring-loaded pressure bar with thumb
and clamp tape roll to rotating shaft. (See Figure 1)
2. With adhesive side down, thread tape between
metal guide and roller. (See Figure 2)
3. Pull tape towards you. Tear off any excess tape. Now
you are ready for dispensing. (See Figure 3)
4. Pull tape over smoothing roller allowing tape to
unroll freely off tape wheel. (See Figure 4)
Figure 1
Figure 4
PAGE 1 OF 3
1-800-295-5510
uline.com
OPERATION
OPERATING
1. Start on side of box, roll tape applicator over corner
of box, centered on top seam. (See Figure 4)
2. Pull dispenser across box top seam, applying
pressure to applicator roller to obtain a tight seal.
(See Figure 5)
3. End tape web 2⁄" to 3" (63.5mm to 76.2mm) past
the end of the box. (See Figure 6)
4. Bring dispenser tape wiper down against corner of
box, push down and twist slightly to cut and wipe
tape end to back side of box. (See Figure 6)
Figure 2
Figure 5
START
HERE
Para Español, vea página 2.
Pour le français, consulter la page 3.
Figure 3
Figure 6
1020 IH-2960