Filling The Water Tank - DCOOK 8120001 Manual De Instrucciones

HOW TO USE
• BEFORE USING THE BRUSH
Remove all the labels and any manufacturing residue from the
head with a soft cloth. Always check the garment`s label for ironing
instructions before using the device.

• FILLING THE WATER TANK

You are recommended to use demineralised water.
Unplug the brush from the mains to let it cool down and place it horizontally
on a stable, level surface.
To remove the water tank, press the two buttons at the same time and pull
the tank outwards for easy filling.
1) To fill the water tank, open the tank lid by gently pulling the tab upwards
and pour water with the aid of the measuring cup. Never go above the
MAX mark on the iron.
2) Then close the lid and slide the tank into the iron until you hear a click.
This indicates that the tank has been properly positioned.
• STEAM BURST BUTTON
This device has two operation modes:
1. Steam burst. In order to use the steam when it is needed, just press
the button. Whenever you press the button, the device emits steam and
whenever you stop pressing it, it will stop emitting steam.
2. Continuous steam. When the steam button is pressed and the tab is
slid downwards, the device is locked, and steam is generated continuously.
You do not need to keep pressing the button for steam to be generated.
If you want to unlock the button, just slide the button upwards, and the
steam will no longer be generated continuously.
USING THE STEAM BRUSH
• Before you use the device, make sure that the steam button is not
pressed and the water tank is full.
• Completely unwind the cord and plug the device into the mains. The
22