Cedar Ridge MTF4TPU Manual Del Usuario página 13

Marking Screw Locations
1. Tape mounting bracket to wall where
heater will be located. Make sure mount-
ing bracket is level.
WARNING: Maintain mini-
mum clearances shown in Figure
4, page 11. If you can, provide
greater clearances from floor
and joining wall.
2. Mark screw locations on wall (see Fig-
ure 8).
Note: Mark only last hole on each end of
mounting bracket. Insert mounting screws
through these holes only.
3. Remove tape and mounting bracket from
wall.
11 / "
1
10
16
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
Figure 8 - Mounting Bracket Clearances
Attaching Mounting Bracket To Wall
Note: Wall anchors, mounting screws, and
spacers are in hardware package. The hard-
ware package is provided with heater.
Attaching to Wall Stud Method
For attaching mounting bracket to wall studs:
1. Drill holes at marked locations using 9/64"
drill bit.
2. Place mounting bracket onto wall. Line
up last hole on each end of bracket with
holes drilled in wall.
200032-01A
All manuals and user guides at all-guides.com
INSTALLATION
3. Insert mounting screws through bracket
4. Tighten screws until mounting bracket is
For attaching mounting bracket to hollow
walls (wall areas between studs) or solid walls
(concrete or masonry):
1. Drill holes at marked locations using
2. Fold wall anchor as shown in Figure 9.
3. Insert wall anchor (wings first) into hole.
4. For thin walls (1/2" or less), insert red key
IMPORTANT: Do not hammer anchor key! For
thick walls (over 1/2" thick) or solid walls, do
/ "
1
16 not pop open wings.
5. Place mounting bracket onto wall. Line up
12 / "
3
4
6. Insert mounting screws through bracket
Min.
7. Tighten screws until mounting bracket is
Figure 10 - Popping Open Anchor Wings
www.usaprocom.com
and into wall studs.
firmly fastened to wall studs.
Attaching to Wall Anchor Method
5/16" drill bit. For solid walls (concrete or
masonry), drill at least 1" deep.
Tap anchor flush to wall.
into wall anchor. Push red key to "pop"
open anchor wings (see Figure 10).
last hole on each end of bracket with wall
anchors.
and into wall anchors.
firmly fastened to wall.
Figure 9 - Folding Anchor
For Thin Walls
13