Installation - Glacier bay TL-7620HC-RW Guía De Uso Y Mantenimiento

Installation

1
Removing the old toilet
Turn off the water supply and ush the tank completely.

Towel or sponge remaining water from the tank and bowl.
Disconnect and remove the old water supply line.

Remove the bowl from the oor by removing the bolt caps

and the oor bolt nuts.
Remove the oor bolts from the toilet ange and clean old

wax, putty and sealant from the base area.
Temporarily plug the oor ange with a towel or cover to

block sewer gases from escaping.
NOTE: The mounting surface must be clean and level
before the new toilet is installed. .
2
Installing the oor bolts
Insert the oor bolts (AA) into the slots on the toilet ange (1)

with the bolt heads down and threaded ends facing up. The
heads of the oor bolts (AA) should be perpendicular
opening in the toilet ange
Ensure the oor bolts (AA) are parallel to the wall. When set,

hand tighten the hex nuts (BB) onto the oor bolts (AA) to
secure.
5
Please contact 1-855-434-5224 for further assistance.
HOMEDEPOT.COM