Installing The Toilet; Securing The Toilet - Glacier bay TL-7620HC-RW Guía De Uso Y Mantenimiento

Installation (continued)
3
Installing the wax ring
Turn the toilet bowl (B) upside down onto a towel or

cushioned surface. With the rounded (tapered) end of the
wax ring (CC) facing the toilet, place the wax ring (CC)
around the raised outlet ring of the bowl (B), and press
rmly enough so the wax ring (CC) adheres to the bowl (B).
5

Securing the toilet

From the backside of the toilet (B), place the plastic discs

(DD) over the oor bolts (AA), noting 'this side up' on the
top of the discs.
Tighten the oor bolt wing nuts (EE) onto the oor bolts

(AA) to secure the position of the plastic discs (DD).
Place the bolt cap covers (FF) over the oor bolts (AA) and

snap into place.
4

Installing the toilet

Place the toilet bowl (B) over the toilet ange (1) in alignment

with the oor bolts (AA) so they protrude through the slots on
the base of the toilet bowl (B). Press down on the toilet bowl
(B).
6
Installing the tank
Attach the rubber sealing gasket (KK) to the center drain hole

under the tank (A).
Gently place the tank (A) on the toilet bowl (B) with bolts (II)

protruding out underneath.
Place an oval metal washer (LL) followed by a wing nut (MM)

onto each protruding bolt (II).
Tighten the wing nuts (MM) enough so that the tank (A) sits at

on the toilet bowl (B). Make sure the tank (A) is parallel to the
wall and straight on the toilet bowl (B).
CAUTION: Do not overtighten the nuts. Severe damage
may occur.
6