Connecting To The Power Supply; Extensions; Wet And Dry Applications; Maintenance And Repairs - American Sanders CAV 50 Manual De Instrucciones

Connecting to the power supply

WARNING!
■
Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■
Before plugging the vacuum cleaner into the
electrical mains, make sure that the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■
Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
■
Make sure that the vacuum cleaner is turned off.
■
The plugs and connectors of the connection
cables must be protected against splashed water.
■
Make sure that connections to the electrical
mains and plug are correct.
■
Use the vacuum cleaners only when the cables
that connect to the electrical mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■
Regularly check that the electric cable does not
show signs of damage, excessive wear, cracks or
ageing.
WARNING!
When the vacuum cleaner is operating, do not:
■
Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■
Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■
Only replace the electric power cable with one of
the same type as the original: SJT. The same rule
applies if an extension is used.
■
The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualifi ed
personnel.

Extensions

If an extension cable is used, make sure it is sized properly for
the power requirements of the vacuum cleaner.
WARNING!
Only the extension cord supplied with the appliance
must be used to connect this vacuum cleaner to the
power supply socket.
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons exposed and could short
circuit the power supply.
04/2010

Wet and dry applications

WARNING!
Vacuuming liquids is not allowed with these vacuum
cleaners
[ NOTE ]
The supplied fi lters and the bag (if applicable) must be
installed correctly.
WARNING!
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.

Maintenance and repairs

WARNING!
Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts or
converting it to another version/variant, the plug must
be disconnected from the socket.
■
Carry out only the maintenance operations
described in this manual.
■
Use only original spare parts.
■
Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety.
WARNING!
Contact manufacturer's technical service or sales
network for maintenance operations not described in
this manual.
5
CAV 50 - CAV 100
US
C346