Publicidad
Idiomas disponibles
Idiomas disponibles
Functionality and Characteristics
This radio-networked smoke detector with volume switch operates according to the
optical principle and has a measurement chamber in which penetrating smoke
particles are detected. If the alarm threshold is exceeded, a clamorous alarm
sounds. In networked smoke detectors, the alarm is recognized by all other
detectors with the same code. These detectors then also sound their alarms. The
alarm remains activated for as long as smoke is found in the detection chamber.
The alarm is not turned off until the measurement chamber is smoke-free.
• Monitoring area: 40 m
• Battery-operated (1x 9V battery)
• Alarm memory function
• Automatic recognition of battery level
• Battery case monitor
(smoke detector can only be installed with battery inserted)
• Simple cover assembly
What to do in case an alarm sound is triggered
• Immediately leave the residence ! Every second counts;
do not lose any time to getting dressed or carrying objects.
Use an escape route!
• Do not open any doors without first inspecting the surface.
If it is hot or smoke can be seen underneath the door, do not open the door !
Use an alternative escape route. If the surface is cool, press a shoulder against
it, open it slightly and be prepared to close the door if heat and smoke enter.
• If the air is smoky, stay close to the floor and breath through a damp cloth
if possible.
• Once out of the building, go to the agreed upon meeting point and do not
return to the house.
• Call the fire department outside the burning building.
Installation locations
• Place the smoke detector directly on the ceiling in the center of the room.
• Preferred rooms are living rooms, bedrooms and children's rooms. If there are
multiple bedrooms, install additional smoke detectors in each bedroom.
• Smoke detectors should also be installed in hallways in order to monitor them,
as fires can easily be ignited in stairways in particular (chimney effect).
Several detectors may be necessary in long hallways.
The distance between the detectors should not be greater than 8 m.
• When installing on the ceiling, ensure that the detector is at least 15 cm
from the side wall and at least 50 cm from each corner.
2
within one room
10
Publicidad
