Publicidad
Idiomas disponibles
Idiomas disponibles
Special code "0"
• The code "0" has a priority function.
• If the code "0" is set on a radio smoke detector, the detector can receive
the alarm signals from detectors with all other codes, with a delay of approx.
3 min., and transmits an alarm directly to all other detectors that are set
with code "0". This function can be useful for the widest variety of applications,
such as in a multi-family house!
• If an alarm is detected in a radio smoke detector that is set with code "0",
this detector transmits the alarm to all other detectors without delay.
• Example: A radio smoke detector in the staircase (code 0) detects smoke
and reports it to all radio smoke detectors in its radio transmission range.
This means that the detectors on the ground floor (Code 1, for example),
as well as all other units (Code 2 ...) are signaled, as well.
Alarm memory function
If a smoke alarm triggers due to smoke or source of interference
(but not from pressing the test button), then the triggering is saved on this
smoke detector for up to 12 hours.
The saved triggering is then indicated every 8 seconds by a beep and
simultaneous blinking.
The functionality of the smoke detector is not influenced during this time.
The memory can be cleared by pushing the test button until an alarm sound
can be heard.
Volume switch /Sensitivity reduction
The sensitivity reduction can be useful in certain situations
(when smoking a cigarette, for example).
• If there is risk of a false alarm, the sensitivity can be reduced for approx.
10 minutes with the help of the test button. To do so, press the test button
for approximately 2 to 3 seconds. The LED then blinks a second time every
8 seconds.
• After approx. 10 minutes, the detector functions at normal sensitivity again.
• The sensitivity can also be manually reset to the normal state by pressing
the button again.
Note:
Ensure that the selected code is entered precisely.
An appropriate screwdriver should be used to make the
adjustment!
13
Publicidad
