DeWalt D271059 Traducido De Las Instrucciones Originales página 21

Installing the laser window (fi g. B1 & B2)
• Loosen the screws (6) and remove them. Retain
the screws for the installing of the laser head.
• Remove the cover (7).
• Slide the laser window (5) into the exposed
recessed area. Make sure that the notch (8) is
facing up.
• Fit the laser window (5) using the screws (9).
Installing the laser head (fi g. C1 & C2)
• Loosen the screws (10) and remove them using
the hex key provided. Remove the cover (11).
• Fit the laser head (3) to the saw arm (12) using
the screws (6).
• Do not yet refi t the cover (11).
Installing the switch box (fi g. A & D1–D4)
WARNING: Make sure that the power
tool is unplugged.
• Loosen the screws (13) and remove them.
• Take off the cover (14).
• Attach the connector (15) from the laser unit to
the connector (16) of the switch box.
• Take the connector (17) out of the cavity (18).
• Attach the connector (19) from the switch box to
the connector (17) of the internal wiring.
• Carefully place the connectors into the provided
area.
• Fit the switch box (2) to the saw arm (12) using
the screws (13).
Adjusting the laser head (fi g. A, E1–E7, G)
• Adjust the saw head for a vertical crosscut.
• Remove the cover (11) if fi tted.
• Switch on the laser.
• Perform the adjustments as described below in
order to achieve correct alignment of the laser line.
• Repeat these adjustments as necessary until the
laser line is correctly aligned.
• Switch off the laser.
• Refi t the cover (11) using the screws (6). Make
sure the notch (14) is located over the cable (15).
• Place the hex key (4) in the storage for future
adjustment.
• Insert the trigger lock (22) into the padlock hole
of the trigger switch (24). Push the trigger lock
(22) until it snaps into place.
Adjustment perpendicular to the fence (fi g. E2 & E3)
• Pull down the head until the blade just enters the
saw kerf (19).
• Place a set square (20) on the table and up against
the blade (21).
WARNING: Do not touch the tips of the
blade teeth with the square.
• Using the hex key (4), turn the adjustment screw
(16) as necessary to align the laser line with the
edge of the square.
Adjustment parallel to the blade (fi g. E4 & E5)
• Raise the saw head into its upper rest position.
• Place a set square (20) on the table and up
against the kerf (19), aligning the edge of the
square with the laser line.
• Pull down the head and observe the laser line.
WARNING: Do not touch the tips of the
blade teeth with the square.
• If the line moves, turn the adjustment screw (17)
as necessary to align the laser line with the edge
of the square.
Aligning the laser line (fi g. E6 & E7)
• Pull down the head until the blade just enters the
saw kerf (19).
• Place a set square (20) on the table and up
against the blade (21).
WARNING: Do not touch the tips of the
blade teeth with the square.
• Turn the adjustment screw (18) as necessary to
align the laser line with the left edge of the blade.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
• Make sure the attachment has been set up
securely.
• Extreme temperature changes cause movement
of internal parts that may affect the accuracy of
the attachment. Regularly check the accuracy while
using the attachment under these circumstances.
Also refer to the instruction manual of your
power tool.
E N G L I S H
19