Adjusting The Speaker Volume - Stanley FATMAX FMHT77652 Manual De Instrucciones

To change to a lower Accuracy:
On the Detector's LCD screen, view the current
1.
accuracy setting (Figure
Press to change to the desired accuracy setting.
2.
Accuracy
Press
Setting
≤ 1 mm
Default
≤ 0.05 in
≤ 1/16 in
MEDIUM
≤ 2 mm
x1
≤ 0.10 in
≤ 1/8 in
≤ 5 mm
x2
≤ 0.20 in
≤ 1/4 in
LOWEST
≤ 10 mm
x3
≤ 0.50 in
≤ 1/2 in
Changing the Measurement Type
By default measurements are displayed on the LCD
screen in millimeters (mm). You can change to decimal
inches or fractional inches.
On the Detector's LCD screen, view the current
1.
measurement type (Figure
Press to change the measurement type.
2.
).
E
3
On LCD
screen
HIGH
LOW
).
E
2
Measurement
Press
IN
MM
Default
x1 decimal inches
x2 fractional inches

Adjusting the Speaker Volume

By default the detector's volume is set to LOUD. You
can lower the volume or turn the sound off.
On the Detector's LCD screen, view the current
1.
speaker volume setting (Figure
Press to change to the desired speaker volume
2.
setting.
Speaker
Press
Default
x1
x2
Detecting a Laser Beam
While powered ON, position the Detector where the
1.
laser beam is projected.
• Use the Detector's bubble vials (Figure
maintain a level plane.
• Within 45° of the laser source, point the
reception window (Figure
beam.
2. Use the following indicators to align the
Detector's Reference Line (Figure
laser beam.
On LCD
Type screen
millimeters mm
in
in
).
E 4
On
Volume
LCD screen
LOUD
SOFT
MUTE No Icon
A
) toward the laser
A
3
) with the
A 1
GB
) to
2
7