Maintenance And Care - Stanley FATMAX FMHT77652 Manual De Instrucciones

Changing the Reference Line Position
To move the Reference Line from its default position:
Make sure the Detector is currently detecting the
1.
laser beam at a desired position above or below
the default Reference Line position.
Press to set the new Reference Line position.
2.
The Digital Height Reading (Figure
to 0 and the Oset icon (Figure
the LCD .
Use the Detector with the new Reference Line
3.
position.
To return the Reference Line to its default position,
4.
press .
Turning the Detector OFF
Press and hold for approximately 3 seconds to
turn the Detector OFF.
NOTE: The Detector will automatically power OFF after
not detecting a laser beam for 30 minutes.

Maintenance and Care

Exterior plastic parts may be cleaned with a damp
cloth. Although these parts are solvent resistant,
NEVER use solvents. Use a soft, dry cloth to remove
moisture from the tool before storage.
End of Life
DO NOT dispose of this product with household waste.
ALWAYS dispose of batteries per local code.
PLEASE RECYCLE in line with local provisions for
the collection and disposal of electrical and electronic
waste under the WEEE Directive.
Warranty
Go to www.2helpU.com for the latest warranty
information.
) changes
E
8
) appears on
E 9
GB
9