Digi Sport Instruments DT480 Modo De Empleo página 4

www.digisportinternational.com
INSTRUCTION MANUAL
STOPWATCH DT480
FEATURES:
CHRONOGRAPH
 Display of Section and Total Lap.
 Measure up to 9 hours 59
minu6tes 59.99 seconds.
 50 Recallable Lap time Memories.
 Lap counter counting up to 99
TIMER
 Countdown Timer, maximum 10
hours count down.
 30 seconds shuttle countdown for
time out.
PACEMAKER
 From 0.1sec/beat (600 beats/min.)
to 2 beats/min
 Beat counter counting up to 99.
CHRONOGRAPH OPERATION
Depress D to select the operating
mode. The 'CHRONO' indicator is
shown. Depress A to start.
Depress B to read the lap
time. The lap time (section lap ) is
shown at upper row, the split time
(total elapsed time ) is shown lower
row.
* After 10 seconds the display
will automatically be released to
show the running Lap time at the
top row and the running Total time at
the lower row, The LAP counter
automatically advances by 1.
Depress B to latch the second
split time.
Depress A to stop counting.
If A is depressed within 10 sec.
i.e. before the display is released to
running, depress B to read total time
and the last lap time.
* If lap time is greater than
59'59"99. Lap counter will blank out
to allow for the display of hour.
Depress C to recall last lap data
(memory can only be recalled when
chronograph is stopped).
Depress C to again to recall
2nd lap data.
Depress C again to recall the
3rd memory data (since in this
example the stopwatch is stopped
after 2nd lap, the stopped time is
stored in the 3rd memory local on
and the STOP indicator is also
displayed.) Up to 8 stored lap lime
data can be recalled by depressing
C.
Depress B to reset CHRONO
and clear up all memories.
TIMER OPERATION
Depress D to select the timer
mode. The indicator is shown. The
hour digit is flashing and ready for
setting. Press B to select digits and
A to set digit. Digit will be advanced
by + 1 for every depression of A.
When the last 2 digits are set.
Depress B to complete the preset
process. The upper and lower row
will show the same preset time.
The 2 digits under the
COUNT indicator is a counter to
record the number of completed
preset time cycles. (Count will be
blanked out it preset time is greater
than or equal to 1 hour).
Start / stop timer by depressing
A.
When the timer is at the
"STOPPED" condition depress C will
immediate start a 30 sec.
Countdown, which
Is displayed at the top row. At the
end of this 30 sec. a long beep will
be generated.
Depress C while this
countdown is in progress will
terminate it and the display will
return to its original condition.