Publicidad
Idiomas disponibles
Idiomas disponibles
Down-counting will continue by
depressing A.
At 30 seconds before timer
reaches zero. 4 short beeps will be
generated to indicate there is still 30
sec. to go.
When the timer reaches zero,
10 long beeps will sound.
Timer will restart automatically
from the pre-setting time after
countdown is finished.
PACER OPERATION
In the TIMER mode, if the
preset is <=30 sec., only 1 short
beep will sound when the
countdown reaches zero Since the
timer automatically recycles as
soon as it reaches zero. A
beeping sound with a period can
be generated. The pacer can be set
from a period of 0.1 sec (600
beats/minute).
beats/minute) to 30 sec (2
CARE OF YOUR STOPWATCH:
*WATER RESISTANCE
The
stopwatch
is
designed
withstand accidental contact with
water
such
as
splashes
raindrops, but it is not designed for
use in water. Do not operate the
buttons when the stopwatch is wet.
*TEMPERATURE
Do not leave your stopwatch under
direct sunlight or in very high
temperatures for a long time, the
display may become black. Do not
leave your stopwatch in very low
temperature as this may cause a
slight time loss or gain and the
change of digits becomes slow. In
both cases the above conditions will
be corrected when the stopwatch
returns to normal temperature.
*SHOCKS
Be
careful
not
to
drop
stopwatch or hit it against hard
surfaces
as
it
may
cause
mechanical damage.
*STATIC ELECTRICITY
The
integrated
circuit
stopwatch can be affected by static
electricity. If the static electricity is
very strong a permanent damage
can occur. Be careful of the screen
of the TV set and the wearing of
clothing made of synthetic material
in dry weather; in such cases a very
strong
generated.
*MAGNETISM
Not affected
to
*CHEMICALS
or
Do not expose your stopwatch to
solvents such as gasoline and
alcohol,
cleaners, paints etc as they may
cause damage to the stopwatch.
*BATTERY CHANGE
When the display becomes dim of
faded out, battery replacement is
necessary.
1. Unscrew and remove back cover.
2. Unscrew the battery contact.
3. Replace with fresh lithium battery
CR2032 or equivalent.
4. Before putting in the fresh battery
makes sure that the triangular
contact is in the triangular slot under
the battery.
5. Use a small metal tool (such as a
your
tweezer
momentarily short circuit the AC pad
a
at the lower side of the battery.
6. Rescrew the back cover.
in
your
THE WARRANTY DOES
NOT COVER THE
Use a battery of
static
electricity
can be
spray
of
cosmetics,
of
screw
driver)
to
BATTERY
quality.
Publicidad
