Glacier bay FW0B4600CP Guía De Uso Y Cuidado página 5

Installation (continued)
3
Installing the faucet handles
Remove the preassembled guide washers (E),
metal washers (D), and rubber washers (C)
from the hot and cold faucet handles (A and K).
Loosen the screws on the guide washers (E)
until the ends of the screws are flush with the
face of the guide washers (E).
Insert the hot and cold faucet handles (A and
K) into the installation holes on the sink.
Attach the faucet handles (A and K) underneath
the sink using the rubber washers (C), metal
washers (D), and guide washers (E). Securely
tighten the screws on the guide washers (E).
A
A
C
D
E
E
K
K
E
4
Installing the drain body
Remove the drain flange (L) from the drain
body (O).
Apply silicone caulk (not included) under the
drain flange (L) and place the drain flange (L)
over the drain hole in the sink.
From underneath the sink, screw the drain
body (O) onto the drain flange (L). Ensure that
the opening (1) for the ball rod on the drain
body (O) faces towards the rear of the sink.
Tighten the rubber washer (M) and lock nut (N)
on the drain body (O).
L
L
M
N
O
5
Please contact 1-855-434-5224 for further assistance.
1
HOMEDEPOT.com