Ego Power+ FN1800 Manual Del Usuario página 17

ASSEMBLING THE WHEELS
(Fig. 2)
1. Align the hole of one of the
wheels with the wheel axle of the
fan, and mount the wheel onto
the axle.
2. Thread one of the wheel screws
through the hole of the wheel into
the wheel axle, then tighten the
screw with the supplied wrench.
3. Snap the hubcap onto the wheel.
4. Assemble the other wheel following above steps 1 – 3.
ATTACHING THE TOP HANDLE
(Fig. 3)
1. Align four supplied screws with
the holes in the top handle and
the holes in the fan enclosure.
2. Insert the screws and then
tighten them with the supplied
wrench.
56V LITHIUM-ION CORDLESS MISTING FAN — FN1800/FN1800-FC
2
Screw with washer
3
Wheel
Hubcap
Wheel Axle
Wrench
Screw with Washer
Top Handle
Screw Hole
Wrench
17