Sensor Function
Output #1
Hold Time
Output #2
Hold Time
Output #1 Logic
Output #2 Logic
Cross-Traffic
Optimization (CTO)
Interference Filter
Slow Motion
Detection (SMD)
(People only)
Remote control
communication
address
Set Access Code
(To unlock sensor
see page 4)
Delete Access Code
Lock Sensor to
Remote Access
Factory Reset
6
RegloBeam 2
Description
Function
Factory Settings in bold with *
0.2 sec
0.5 sec
1.0 sec
*
2.0 sec
F 1
5.0 sec
Pulse on exit
Output steadily on (for testing purposes only)
Output steadily off
0.2 sec
0.5 sec
1.0 sec
2.0 sec
F 2
5.0 sec
Pulse on exit
Output steadily on (for testing purposes only)
*
Output steadily off
NO
*
F 3
NC
NO
*
F 4
NC
Off - Door always activates when any crossing
*
Low - Door occasionally activates when crossing traffic is detected
F 5
Medium - Door rarely activates when crossing traffic is detected
High - Door ignores most crossing traffic
*
Off
On - Use when electromagnetic sources such as fluorescent bulbs,
F 6
HID lights, wireless systems, motors/inverters are causing interference
*
Off
On - holds door open as long as people are slightly moving in front of the door
F 7
(LED will blink)
– Available addresses that can be set by remote
*
Factory setting
F 8
Reads & sets address (1-4) set by DIP switch on sensor unit
Once address is changed, press
i
Before setting access code, always use delete access code
D 9
To set access code, enter
1 1 1 1 - 9 9 9 8 ending with
To delete access code, enter
Forces sensor to exit programming mode.
F 8
Further changes cannot be made until programming mode is entered again
(See section 5.1).
Completes factory reset
A
All settings listed in this table with
to re-establish connection with sensor
G
followed by any 4-digit number from
D
. Access code is now stored.
D
9 9 9 9 ending with
D
*
will be restored.
.
D
* Factory settings