Honeywell THP1000 Instrucciones De Instalación

THP1000 Power Base for the
Prestige Thermostat
APPLICATION
The THP1000 Power Base for the Prestige thermostat is a
battery pack that permits demonstration of the Prestige
thermostat without wiring it to a power supply.
INSTALLATION
1. Install six new AA batteries as shown in Fig. 1. Use
Alkaline or Lithium-ion batteries.
2. Remove coin cell battery from Prestige thermostat.
Fig. 1. Install AA batteries.
3. Snap the power base onto the thermostat, as shown in
Fig. 2.
Fig. 2. Install power base to thermostat.
4. Turn on the power base using the On/Off switch as
shown in Fig. 3.
5. The thermostat is now powered and can be used for
demonstrations.
6. When finished with the demonstration, switch power
base to Off.
Troubleshooting
If Prestige screen flickers or goes black, switch power Off for 3
M29910
seconds, then switch power back On.
M29911
INSTALLATION INSTRUCTIONS
ON OFF
Fig. 3. On/Off switch.
M29912
69-2408EFS-01