Publicidad
STEP 1
With the large cylinder of the
gas spring facing up, determine
if the gas spring needs to switch
directions by deciding which
direction the board will face
inside the cabinet, left or right.
If in the correct position, move on
to Step 2; if not, uninstall the two
small screws that are attaching
the gas spring to the soft close/
swivel mechanism. Flip the gas
spring and reattach it to the
mechanism (See Figure 1).
Note: The large cylinder should
always face up.
#2
#2
#2
STEP 2
To ensure the feet reach the floor
when the ironing board is in use,
measure and mark at least 36- 3/4"
(930 mm) up from the floor.
Then to ensure the swivel
mechanism does not interfere with
the cabinet sidewall edge, measure
and mark 1-15/32" (37 mm) from
the edge of the cabinet sidewall
for the first mounting hole.
In the opened position, line up the
soft-close/swivel mechanism with
your marks; if using systems holes,
attach it to the cabinet sidewall
using (4) M5 x 9mm euro screws
or use (4) #8 x 5/8" wood screws
if system holes are not being used
(See Figure 2).
1
8
#2
#2
#2
PZ2
#2
#2
2
Right
FIG. 1
FIG. 2
Customer Service: 800-626-1126 | rev-a-shelf.com
Left
1-15/32" (37 mm)
Large Cylinder Head
Publicidad
