Tabla De Contenido; Important Safety Instructions - Delta 37-071 Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS ................................... 2
SAFETY GUIDELINES - DEFINITIONS .................................... 3
GENERAL SAFETY RULES ...................................................... 3
ADDITIONAL SPECIFIC SAFETY RULES ............................... 4
POWER CONNECTIONS .......................................................... 6
MOTOR SPECIFICATIONS ....................................................... 6
GROUNDING INSTRUCTIONS ................................................ 6
EXTENSION CORDS ................................................................ 7
KEY FEATURES AND COMPONENTS .................................... 7
FUNCTIONAL DESCRIPTION .................................................. 7
PRODUCT SPECIFICATIONS ................................................... 8
UNPACKING .............................................................................. 8
ASSEMBLY ................................................................................. 9
Fence Assembly ..............................................................................................9
Fence Angle Lock Assembly ................................................................... 10
Align Cutterhead to Outfeed Table ..................................................... 10
Connecting to Dust Collector................................................................. 11

IMPORTANT SAFETY INSTRUCTIONS

READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING
THIS EQUIPMENT. Failure to follow all instructions listed below, may result in electric shock, fire,
and/or serious personal injury or property damage.
Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all
machinery, there are certain hazards involved with the operation of the product. Using the machine with
respect and caution will considerably lessen the possibility of personal injury. However, if normal safety
precautions are overlooked or ignored, personal injury to the operator may result. Safety equipment such
as guards, push sticks, hold-downs, featherboards, goggles, dust masks and hearing protection can reduce your
potential for injury. But even the best guard won't make up for poor judgment, carelessness or inattention. Always
use common sense and exercise caution in the workshop. If a procedure feels dangerous, don't try it. Figure out
an alternative procedure that feels safer. REMEMBER: Your personal safety is your responsibility. For additional
information please visit our website www.DeltaMachinery.com.
This machine was designed for certain applications only. DELTA
strongly recommends that this machine not be modified and/or used for any application other than
that for which it was designed. If you have any questions relative to a particular application, DO NOT use the
machine until you have first contacted DELTA
If you have any questions relative to its application DO NOT use the product until you have written DELTA
Equipment Corporation and we have advised you. Contact us online at www.DeltaMachinery.com or by mail at
Technical Service Manager, DELTA
Information regarding the safe and proper operation of this tool is available from the following sources:
• Power Tool Institute, 1300 Sumner Avenue, Cleveland, OH 44115-2851or online at www.powertoolinstitute.com
• National Safety Council, 1121 Spring Lake Drive, Itasca, IL 60143-3201
• American National Standards Institute, 25 West 43rd Street, 4 floor, New York, NY 10036 www.ansi.org - ANSI 01.1
Safety Requirements for Woodworking Machines
• U.S. Department of Labor regulations www.osha.gov
TABLE OF CONTENTS
® to determine if it can or should be performed on the product.
®
Power Equipment Corporation, 99 Roush St., Anderson, SC 29625.
2
OPERATION ............................................................................. 12
Starting and Stopping the Jointer ........................................................ 12
Locking the Jointer Using the Safety Key .......................................... 12
Adjusting Fence Position.......................................................................... 12
Feeding Stock ............................................................................................... 13
Jointing Beveled Stock .............................................................................. 13
Calibrating the 45°/90°/135° Stops ...................................................... 14
Depth Adjustment ...................................................................................... 15
MAINTENANCE ...................................................................... 16
Changing the Cutter Knives .................................................................... 16
OTHER RECOMMENDED MAINTENANCE .......................... 16
ACCESSORIES ........................................................................ 17
WARRANTY ............................................................................. 17
REPLACEMENT PARTS .......................................................... 18
SERVICE AND REPAIRS ......................................................... 18
FRANÇAIS ................................................................................ 20
ESPAÑOL ................................................................................. 38
®
Power Equipment Corporation
® Power