Vaporetto PRO 95_TURBO FLEXI Manual De Instrucciones página 23

CORRECT USE OF THE PRODUCT
This appliance is intended for internal domestic use as a steam
cleaner, in accordance with the descriptions and instructions
contained in this manual. Please read these instructions
carefully and keep them. If this manual is lost, it can be
consulted and/or downloaded from the website www.polti.com.
Never leave the appliance exposed to weathering.
Correct use of the product is only as detailed in this instruction
manual. Any other use may damage the appliance and
invalidate the warranty.
Tests performed by a third party, independent laboratory certify
that Vaporetto kills and removes 99.99% of germs and bacteria
if used based on the instructions included in this manual with
the microfibre cloth mounted and for a continuous operating
time of 15 seconds.
INFORMATION FOR USERS
Pursuant to European Directive 2012/19/EU, regarding electric
and electronic appliances, this appliance must not be dispo-
sed of with domestic waste, but should be sent to an official
collection facility. This appliance complies with EU Directive
2011/65/EU.
The crossed-out bin symbol on the appliance indica-
tes that, at the end of its useful lifespan, the product
must be disposed of separately from other waste.
Therefore, at the end of its life, the user must hand
over the appliance to an appropriate collection centre for
electric and electronic waste. Proper separate waste collection
to facilitate the subsequent recycling, treatment and environ-
mentally compatible disposal of the appliance helps to pre-
vent negative effects on the environment and human health,
and promotes recycling of the materials the product is made
of. Unlawful disposal by the owner may result in the sanctions
envisaged by current legislation.
Polti S.p.A. reserves the right to change equipment or accessory
specification without prior notice.
Before leaving our factory all our products are rigorously tested.
This is the reason why your VAPORETTO may contain some
residual water in the boiler.
WHICH WATER TO USE IN THE BOILER
This appliance has been designed to function with normal tap
water between 8°F and 20°f. If the tap water contains a lot of
limescale use a mix composed of 50% tap water and 50%
demineralised water which is widely available to purchase. Do
not use pure demineralised water.
Warning: check the hardness of the water at the technical office
at your local council or the local water supplier.
If you only use tap water, you can reduce the formation of
limescale by using the special Kalstop (PAEU0094) anti-
limescale product, distributed by Polti, and available for sale at
all major domestic-appliance
www.polti.com.
All manuals and user guides at all-guides.com
Never use distilled water, rain water or water containing
additives (e.g. starch, perfumes), or water produced by other
domestic appliances, by water softeners or filter jugs.
Do not add chemical, natural, detergent, or limescale removing
substances, etc.
1. PREPARATION FOR USE
1.1 Open the tank closing cap (1) and fill the tank with about 1l of
water, making sure that it does not overflow.
This operation must always be carried out when the boiler has
cooled and with the power cable disconnected from the mains.
Thanks to the continuous refill system you do not need to stop
and wait for the appliance to cool down because the tank can be
filled as needed.
1.2 Replace the tank closing cap.
1.3 For the Pro95_Turbo Flexi model open the flap of the built-
in socket and insert the connector of the steam hose (2),
pressing the specific button and making sure that the hooking
pin is inserted perfectly in the specific locking hole on the
socket.
1.4 Connect the cable plug to an earthed power supply of the
correct voltage (3).
Completely unwind the power cable before plugging it into the
mains and before use, and always use the appliance with the
power cable completely unwound.
1.5 Press the boiler switch
the "steam ready" indicator light ( ).
1.6 Wait for the "ready steam" indicator light ( ) to turn off.
The appliance is ready for use.
1.7 Before starting the steam cleaning, you are advised to sweep
or vacuum the surface to be cleaned.
WARNING: When first operating steam, there may be some
drops of water mixed with the steam due to temperature
imbalances.
Direct the first jet of steam onto a cloth.
2. CONNECTION OF ACCESSORIES
All Vaporetto accessories can be connected directly to the
handle of the steam hose or extension tubes as follows:
• Move the locking button on the accessory to the OPEN
• Attach the required accessory to the hand gun or to the
• Move the locking button back to the CLOSED position (7).
• Check that the locking button has engaged and the accessory
is fully connected.
3. STEAM ADJUSTMENT
You can optimise the steam flow by means of the steam
adjustment knob (5). To increase the flow, turn the knob
stores and online at
clockwise. Turning anti-clockwise reduces the flow. Here are
some tips for regulating it:
| 23 |
(4) which will light up together with
position (7).
extension tube.