Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Use your blender for soups,
drinks, pâtés, mayonnaise,
breadcrumbs, biscuit crumbs,
chopping nuts and crushing ice.
Use your mill (if supplied) for
milling herbs, nuts, coffee beans
and purées.
before using your
Kenwood appliance
Read these instructions carefully
G
and retain for future reference.
Remove all packaging and any
G
labels.
Wash the parts: see 'care and
G
cleaning'.
key
blender
filler cap
lid
goblet
sealing ring
blade unit
base
cord storage
speed + pulse control
soup button
ice button
power unit
vents
mill (if supplied)
mill jar
mill lid
to use your blender
1 Fit the sealing ring
blade unit
is located correctly in the
grooved area.
Leaking will occur if the
G
seal is damaged or
incorrectly fitted.
2 Clip the blade unit
base
.
3 Screw the blade assembly onto
the goblet – ensuring the blade
assembly is fully tightened.
Refer to the graphics on the
underside of the blade unit as
follows:
- unlocked position
- locked position
into the
- ensuring the seal
into the
4 Put your ingredients into the
goblet.
5 Fit the filler cap to the lid and
push down to secure.
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the
power unit.
The appliance won't work
G
if the blender is
incorrectly fitted.
8 Plug in and the 2 pre-program
button lights will remain off.
Select a speed (refer to the
recommended speed chart).
9 Choose one of the following
options:
Turn the speed control to the
G
"ON" position and the pre-
program buttons will flash. Then
press one of the pre-
programmed buttons. When the
required program button is
pressed the light on the other
button will go out. The blender
will switch off automatically at
the end of the pre-set time. If
you wish to stop before the pre-
set time, press the selected
program button again.
Select speed 1 (low) to 5 (High)
G
by turning the speed control. At
the end of blending return the
speed control to the "OFF"
position before removing the
blender.
(P) Pulse – operates the motor
G
in a start/stop action. The pulse
will operate for as long as it is
held in position.
NOTE: The pre-program lights
will flash under the following
circumstances:-
Speed control turned to the
G
"ON" position.
The goblet is removed from the
G
power unit without switching the
speed control to the "OFF"
position.
The power unit will not operate
G
until the control is turned to the
"OFF" position and a speed is
reselected.
7
Publicidad
Tabla de contenido
