Festo Emergency Light Controller EduTrainer Manual De Instrucciones página 31

The emergency light module is equipped with an integrated self-test function, which is carried out at regular
intervals. The first self-test is performed a week after commissioning.
Test cycle
weekly
annually
The condition of the emergency light module is signaled via an optical status indicator.
Status-LED
LED not lit up
LED flashes red
LED lights up red permanently
LED lights up green permanently
With the -S2 switch, the connection between emergency light module and battery can be interrupted and
hence a defect of the battery simulated.
•
Switch -S2 is in position "I":
Emergency module and battery are connected with one another.
•
Switch -S2 is in position "0":
Emergency light module and battery are separated from one another and a battery defect thereby
simulated. In this switch position, the integrated battery is not charged.
Note:
The battery is monitored permanent, regardless of the time of the automatic self-test.
The alarm reset occurs within 60 seconds after error elimination.
The Emergency Light Controller EduTrainer
module with voltage during a power failure.
Since the charging time of the battery can be up to 24h, we recommend charging the battery in due
time prior to training.
For this, connect the connections (N 7 L) of emergency light module -T1 with the power supply
(N / L') and switch the supply voltage using the switch -S1.
Make sure that switch S2 is likewise in position "I".
© Festo Didactic 8064074
Emergency light module status
Checking stand-by operation of electronics, lamp and battery
Capacity test of battery by simulation of a power failure. The first capacity test is carried out
8 days after installation or after error elimination.
Emergency light module status
No mains voltage or emergency light module defective.
Lamp defective.
Capacity of battery too low or supply line to battery interrupted.
No fault/emergency module ready for operation
® has an NiCd battery, which supplies the emergency
31