Metra DP-7363B Instrucciones De Instalación página 5

ISO DDIN radio provision
1. To remove the factory steering column
cover from the factory dash panel, pry
(4) round retaining clips from where the
leather meets the large panel. (Figure A)
2. Place the leather cover over the Metra
radio trim panel, place the steering
column bracket over the leather and
secure with the (4) #4 x 3/8" Phillips
screws supplied. (Figure B)
3. Mount the radio to the radio brackets
using the screws supplied with the
radio. (Figure C)
KIT ASSEMBLY
(Figure A)
(Figure B)
4. Locate the factory wiring harness and
antenna plug in the dash and make
all necessary connections to the radio.
Metra recommends using the proper
mating adapters from Metra and/or
AXXESS.
5. Mount the new radio assembly into the
dash.
6. Snap the Metra radio trim panel and
steering column cover into the dash and
reassemble the dash in the reverse order
of disassembly.
(Figure C)
REV. 9/6/2017 INSTDP-7363B
5