STACK-ON PWS-15522-B Manual De Instrucciones página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SECURING THE SAFE
NOTE:
is safe is designed to be placed into a
wall and then secured to the wall studs. Failure to
do so will compromise the safety and security of
the safe.
NOTE ON LOCKING THE SAFE:
needs to be in an upright position, as shown in
gure 1, for the locking mechanism to function
properly. Failure to mount the safe in the correct
upright position will compromise the safety and
security of the safe.
NOTE:
is safe must be secured to two
wall studs so it is anchored to the wall studs
in four locations.
Figure 2 shows the installation of the safe in a wood
framed wall (16" centers). For securing the safe to
the wall studs the safe must be a ached to the wood
studs of the wall through the four pre-drilled
mounting holes in the safe, with the frame of the safe
ush to the wall surface.
In the gure shown, mount the safe between two
wall studs. Cut a hole in the wall the same size as the
back of the safe. Use ller blocks and bo om
support as required. Mark the four hole locations
and drill four 3/16 inch diameter pilot holes. Secure
the safe to the wall studs using 4 lag screws and
washers as shown.(Figure 2)
e safe
Figure 1
16"
Figure 2
ACCESSORIES
Use the adhesive backed straps to secure pistols to the
inside of the safe.
e tags can be used to organize
keys.
e le folder is great for storing documents.
MAINTENANCE
Tools Required:
Phillips screwdriver
5mm Allen wrench
If the door of the safe starts to rub on the door
frame, open the door per the instructions above.
By the door hinges you will nd a threaded stem.
Use an Allen Wrench to tighten the threaded stem.
is will realign the door.
e biometric scanner may be cleaned with
household glass cleaner and a co on cloth.
IMPORTANT
Keep keys in a secure place, away from children.
Keep this record of your serial number in a secure
place separate from your safe. To order a
replacement key set, follow the instructions on the
a ached form.
STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
Filler block
Bottom
support
4
12
40645-1511

Publicidad

Tabla de contenido
loading

Tabla de contenido