Battery Replacement; Clearing The Memory; Selecting A Location - STACK-ON PWS-15522-B Manual De Instrucciones

BATTERY REPLACEMENT

NOTE: Do not mix old and new ba eries. Do not
mix alkaline, standard or rechargeable ba eries.
is safe uses 4 - AA ba eries. Under normal use,
ba eries will last about 1 year.
NOTE: If the ba eries are low, the yellow light will
ash when you start to enter your code.
To replace the ba eries, open the ba ery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
ba eries.
TURNING THE SOUND OFF/ON
Your safe comes with the beep sound turned on.
To turn the sound o , press the scanner with a
recorded ngerprint for 10 seconds until the green
light ashes twice.
To turn the sound on, press the scanner with a
recorded ngerprint until you hear two beeps and
the green light ashes twice.

CLEARING THE MEMORY

To clear the memory of all recorded ngerprints,
locate the reset bu on on the inside of the safe
and press this bu on for about 5 seconds until
the green light ashes 10 times with 10 beeps (if
the sound is turned on). All recorded scans will
be erased.
NOTE: For security you must record a
ngerprint. Failure to do so will compromise
the safety and security of the safe.

SELECTING A LOCATION

e safe is to be mounted in a wall between two
wall studs, and then secured to the wall studs.
For optimal safety and security, the safe should
be installed in an isolated, dry and secure area.
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
3
12
40645-1511