Making Coffee In Automatic Mode; Pre-Infusion Mode; Hot Water; Vaporiser Mode - SEGAFREDO NEW SZ Modo De Empleo Y Mantenimiento

3. Press and release button 6
4. When the required amount of coffee has been obtained in the cup, press button 6
to stop the supply.
5. The supply stops automatically after approximately 1 1 / 2 minutes if it is not stopped manu-
ally by pressing button 6

MAKING COFFEE IN AUTOMATIC MODE

1. Lift cover 11 of the coffee supply unit and place a new coffee capsule 13 in the holder (figure 3).
2. Close the cover and place a cup beneath the coffee supply spout 12.
3. Press and release button 7
4. The pouring stops automatically when the programmed amount of coffee has been supplied.

PRE-INFUSION MODE

Supplying coffee with the pre-infusion function may be enabled or disabled as desired by the
user by pressing the button 8
maximum intensity, and when the button is disabled, the button will be lit up with low intensity).

HOT WATER

Hot water is poured from spout 2 and may be used to prepare hot drinks, warm cups up, dilute
slightly an espresso or prepare a longer coffee, etc.
1. Place a cup beneath the spout.
2. Press button 9 and the hot water pours.
3. When the required amount of hot water has been obtained press button 9
the supply.

VAPORISER MODE

Press the ON/OFF 5 switch to turn on the machine. Without touching the keypad, wait for the
keypad to turn on, open the capsule pushing door 11 press the two coffee icons 6
at the same time. When the other icons disappear, the machine is set for the "steam" program.

STEAM

A jet of steam which may be used to froth milk or to heat other liquids is poured from spout 2
by proceeding as follows:
1. Press and release button 10
steam boiler is building up pressure for supply of steam. When the led is "on fixed" press
button 10 again to deliver steam from the spout.
2. Press button 10

CAPPUCCINO MAKER MODE

Press the ON/OFF 5 switch to turn on the machine. Without touching the keypad, wait for the keypad
to turn on, open the capsule pushing door 11 press the two water 9
same time. When the other icons disappear, the machine is set for the "cappuccino maker" program.
MAKING CAPPUCCINO (only version NEW SZ with cappuccino maker)
Only one cappuccino at a time can be made with the cappuccinatore 17 (figure 6).
1. Prepare an espresso coffee as described under the section "Making coffee".
2. Place a cappuccino cup beneath the cappuccinatore.
24
All manuals and user guides at all-guides.com
and the coffee will start to pour.
and the coffee will start to pour.
(when this function is enabled, the button will be lit up with
. The corresponding light will start to flash. At this stage the
again to stop the steam.
again
again to stop
and 7
and steam 10 icons at the