Braun ThermoScan 7+ connect Manual Del Usuario página 6

Last reading recall
The previous measurement will be displayed during start up.
After this, the measurement
will be displayed in the upper
right-hand corner of the
display with an 'M' next to it.
The memory in the upper right corner will update to the new
reading with the first button press after the reading is completed.
Setting a default Age Precision® value
You have the option to set a default Age Precision age group. This will allow the device
to power on and be used in default selection without re-selecting with each power on.
1. When the device is off, hold both the power button and the Age
Precision button for 4 seconds, the backlight will turn yellow,
you can then release the buttons.
2. All Age Icons will flash continuously until the Age Precision button
is pressed.
3. Press the Age Precision button, the 0-3 month icon will be filled in and
flash and the other icons will be empty. A second button press will
advance to the 3-36 month icon flashing, a third will advance to
36+months flashing. This cycle continues in order with each button
press. A full beep will sound with every button press.
4. After 3 seconds of no button press, the displayed icon will remain on
the screen and a full beep will sound. The device will turn off. When the
device is turned back on, the default will be set.
Default will be set on the device until the batteries are removed and then
4 sec
put back in.
8
4 sec
4 sec
4 sec
3 sec
Changing the temperature scale
Braun ThermoScan Ear thermometer is shipped with the Fahrenheit (°F) temperature scale activated.
If you wish to switch to Celsius (°C) and/or back from Fahrenheit to Celsius, proceed as follows:
1
Make sure the thermometer is turned off.
2
Press and hold the Power button
the display will show this sequence: °F / SET / °C / SET.
3
Release the Power button and Start button , when the desired
temperature scale is shown. There will be a short beep to confirm the new
setting, then the thermometer is turned off automatically.
Care and cleaning
The probe tip is the most delicate part of the thermometer.
It must be clean and intact to ensure accurate readings.
If the thermometer is ever accidentally used without a lens filter, clean the
probe tip as follows:
Very gently wipe the surface with a cotton swab or soft cloth moistened
with alcohol. After the alcohol has completely dried out, you can put a new
lens filter on and take a temperature measurement.
If the probe tip is damaged, please contact Consumer Relations.
Use a soft, dry cloth to clean the thermometer display and exterior. DO NOT use abrasive cleaners.
NEVER submerge this thermometer in water or any other liquid. Store thermometer and lens filters
in a dry location free from dust and contamination and away from direct sunlight.
Additional lens filters (LF 40) are available at most stores carrying Braun ThermoScan.
Replacing the batteries
3 sec
The thermometer is supplied with two 1.5 V type AA (LR 06) batteries. For
best performance, we recommend alkaline batteries.
1
Insert new batteries when the battery symbol appears on the display.
Open the battery compartment. Remove the batteries and replace with
2
new batteries, making sure the poles are in the right direction.
3
Snap battery door into place.
3 sec
Only discard empty batteries. To protect the environment, dispose of
empty batteries at your retail store or at appropriate collection sites
according to national or local regulations.
Calibration
3 sec
The thermometer is initially calibrated at the time of manufacture. If this thermometer is used according
to the use instructions, periodic re-adjustment is not required. If at any time you question the accuracy,
please contact Consumer Relations.
and Start button . After about 3 seconds
9