Hinkley 167 Serie Instrucciones De Instalación

Top Cover Options
16704
16701
16707
16710
Concrete Burial
Cut Ground
Wire
Route to Transformer
HINKLEY LIGHTING 33000 Pin Oak Parkway
 Start Here
SAFETY WARNING: TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A
Top
QUALIFIED ELECTRICIAN OR LOCAL AUTHORITY FOR
CODE REQUIREMENTS.
IMPORTANT OPERATION NOTE: This luminaire is designed
Silicone Gasket
to be operated with Hinkley approved 12 volt AC systems.
Luminaire Mounting
Glass Lens
1. To prevent electrical shock, disconnect transformer from
electrical supply before installation or service.
MR16 Lamp
2. Luminaire may be directly buried in the ground or for
concrete applications, a removable burial sleeve is
included.
Socket and
3. In earth burial applications, the best way to extend xture
Mounting Plate
life is to use sand, gravel or any other material to facilitate
drainage.
4. Strip the two wire leads from the luminaire. Cut o the
Housing
green ground wire. Connect the main supply wires using
the provided silicone lled wire nuts or quick connectors
that are approved for outdoor use.
Note: Wire is to be protected by routing in close proximity to the
luminaire or tting or next to a building structure such as a
house or deck. Wiring should be buried a maximum of 6 inches
(15.2 cm) in order to connect to main supply wire. The main
supply wire must have its length cut o within 6 inches (15.2 cm)
from a building, structure, a luminaire or tting.
Removable Burial
Sleeve
Lamp Replacement
(20w Max 12 volt MR16 Bi-pin Lamp)
1. To prevent electrical shock, turn o transformer from
electrical supply before installation or service.
2. Using a Philips head screw driver, remove top screws and
xture top. Set these aside for use in reassembly.
3. Remove silicone gasket and glass lens. Clean the glass lens
Earth Burial
and inspect the silicone gasket for any signs of wear.
4. Gently pull upward on lamp until it releases from the
socket. Discard lamp replace with new MR16 12 volt lamp.
5. Return the silicone gasket and glass lens. Making sure the
gasket is seated correctly.
6. Screw the xture top back on. Tighten the screws so that
equal pressure is put on the gasket. Example, for the top
with four screws, screw in the top screw then the bottom,
left then right screws.
Note: To maximize performance and life of the xture, only use
a maximum of 4 Watts when using LED lamps.
Avon Lake, OH 44012
Installation Instructions
Family: Hardy Island | Item No. 167XX
(for typical in-ground mounting)
(p)800.442.5539 / (f ) 440.653.5555
All Well Lights
www.hinkleylighting.com