Kenwood SW-20HT Manual De Instrucciones página 3

Connection
Note on connection
1. Be sure to turn off your amplifier before connecting or
disconnecting speaker.
2. This speaker system has a nominal impedance of 6 ohms.
To drive this speaker satisfactorily and safely, use an ampli-
fier which can be connected to the speaker having a load
impedance of 6 ohms.
• Never short-circuit the ª and · speaker cords.
1 Twist wire's 2 Push
conductor
·
Black
Right Left
Note on operation
The power-handling capacity of this speaker system is
indicated in the specifications. Do not operate the speaker
with power exceeding this limitation, as it may damage the
speaker.
3 Insert the 4 Release
conductor
ª
Purple
Speaker terminals (Receiver)
Specifications
Type ........................................................................... Subwoofer
Enclosure ..................................................................Bass-Reflex
Loudspeaker ................................ 160 mm (6-5/16") Cone type
Nominal impedance ............................................................. 6 Ω
Peak input power ...............................................................130 W
Nominal input power..........................................................35 W
Sensitivity .........................................................83 dB / W at 1 m
Frequency response ..........................................35 Hz ~ 500 Hz
Dimensions
Width ........................................................... 215 mm (8-7/16")
Height..........................................................350 mm (13-3/4")
Depth.........................................................342 mm (13-7/16")
Net weight .......................................................... 6.8 kg (15.0 lb)
Accessories
Speaker wire (Purple) ..................................... 4.5 m (14.8 ft)
NOTE: THE GRILLE CANNOT BE REMOVED.
Note:
Kenwood follows a policy of continuous advancements in develop-
ment. For this reason specifications may be changed without notice.
Information on Disposal of Old Electrical
and Electronic Equipment (applicable for EU
countries that have adopted separate waste
collection systems)
Products with the symbol (crossed-out wheeled
bin) cannot be disposed as household waste.
Old electrical and electronic equipment should
be recycled at a facility capable of handling these
items and their waste by products.
Contact your local authority for details in locating
a recycle facility nearest to you.
Proper recycling and waste disposal will help conserve re-
sources whilst preventing detrimental effects on our health
and the environment.
3
English