Priming The Pump - Generac G0071260 El Manual Del Propietario

General Information and Setup
NOTE: Hose attachment styles may vary. Use
only flexible hoses. Hard piping may damage
pump due to cantilever loads.
Figure 2-5.Typical Hose Attachment
NOTE: Strainer sold separately.
4. See Figure 2-6. Suspend and use a
strainer on end of suction line if there is
any mud, sand, or particles that may
cause pump damage.
Figure 2-6.Typical Strainer Attachment
CAUTION
Equipment damage. Use recommended strainer to
prevent debris from entering the pump. Failure to do
so could result in equipment damage.

Priming the Pump

CAUTION
Equipment damage. Before starting engine, verify
pump is primed with liquid and suction strainer is
submerged. Failure to do so will cause pump damage
and void the warranty.
Remove the orange priming cap from the
pump and carefully fill the pump chamber
completely with liquid. Tighten the cap. DO
NOT over tighten.
Figure 2-7. Chemical Priming Plug
Owner's Manual for Chemical Pump
005413
005418
(000241)
(000398)
005457
7