Acuity Brands Lithonia Lighting Quantum ELM4L Manual Del Usuario página 6

page 6
CLSR MODULE REPLACEMENT
With the unit oriented as shown
1
below, flex the left PCB guide for
the charger board outward to
release and remove the left side of
PCB first then remove the charger
board.
To replace the antenna, disconnect
4
antenna from the CLSR module and
then replace (antenna and battery
plate will come preinstalled).
MAINTENANCE
Disconnect the battery connector
2
from charger board and remove
the battery (see page 5 for
additional information)
Make sure all wires are routed
5
properly as not to interfere with
proper assembly of the housing
onto the mounting plate. Then re-
assemble the unit (see also step
5, page 3).
LIFE SAFETY SOLUTIONS
800-705-SERV (7378)
techsupport-emergency@acuitybrands.com
www.lithonia.com
To replace the CLSR module,
3
disconnect the module from
charger board and replace
(antenna shown attached to CLSR
module).
2
1
Part # 912-00027-101
Rev. E, 10/2020
© Acuity Brands Lighting, Inc. 2020
All Rights Reserved.