koban KT14-W-RF Manual De Instrucciones página 3

Programmable Wireless Thermostat
Code: 0769014, Reference: KT14-W-RF
TRANSMITTER INSTALLATION
Installation Location
The thermostat should be mounted on an inner wall ~1.5m above the floor in
a position where it is readily affected by changes of the general room
temperature with freely circulating air.
Opening the Cover
Pull out the battery drawer and use a screwdriver to press on the spot shown
below in order to detach the front shell from its base as shown in the below
Figure.
Mounting
Ensure that the surface is level.
Insert 2 pcs of wall anchors into the holes of the wall.
Fasten the thermostat with 2 pcs of long screws through the 2 mounting
holes.
Insert two fresh AAA alkaline batteries into the drawer according to the
polarity marked inside, then slide the drawer back into the place as shown in
the above Figure.
If there are any display or functional errors, please remove the
batteries for about 30 sec to reset the thermostat.
RECEIVER INSTALLATION
Wiring
There are 2 wiring terminals: L,N and 1,2. Connect "L" and "N" to 230Vac.
Connect "1" and "2" to a heater/cooler.
Push all cables back into the wall prior to fixing to avoid trapping wires. Do not
use any metal conduit or cable provided with a metal sheath. Recommend adding
fuse or protective device in the live circuit.
Caution : Turn off the power and electrical devices before wiring.
Mounting
Fasten the base on the wall with 2 pcs of long screws
RF Addressing
Set the RF address you wish to use. The receiver RF address must match the
transmitter RF address.
Upper position represents 1
Upper position represents 0
Push the upper part straight onto the base until it snaps into place.
(Receiver)
Use a flat screwdriver
to press on the gap at
both sides to detach
the front shell.
Transmitter Key Interface
Keys Function
Up / Comfort
Down / Econ
Program
Override / Return
LCD Interface
Temperature displays "Hi" when temperature is over 40C and displays
"Lo" when temperature is lower than 0C.
Temperature displays "defrost" when temperature is lower than 5°C. For
Heat mode, output is on regardless of the setting temperatures
When "low battery" appears on the display, please replace the batteries.
Start
When the thermostat is powered, the temperature measurement starts.
Room Temperature & Current Time will be displayed and the program
mode is run by default.
Operation Mode
The thermostat operates by 3 different modes.
1. Program Mode
The thermostat controls the room temperature
according to the programs. Each program contains its time slot pattern.
The thermostat runs Comfort or Econ mode according to the current time
slot (Comfort or Econ).
2. Temporary Override Mode
The thermostat controls the room
temperature according to the override temperature temporarily, and
returns to Program mode for the next Comfort or Econ mode transition.
1. Cool
2. Heat
3. Comfort Mode
4. Econ Mode
5. Override
6. Defrost(<5°C)
7. Output On
8. Low Battery
9. Time Slot
Black – Comfort
Nothing - Econ
10. Temperature
11. Time
12. Day
13. Program Number