3.
Permanent Override Mode
The thermostat controls the room temperature
only according to the override temperature.
Simply press
key to switch between the 3 operation modes.
Time Setting
Hold
and
to go to time setting mode.
i) Press
or
to adjust "weekday". Press
ii) Press
or
to adjust "hour". Press
iii) Repeat the same process for "minute".
Press
for exit after the time setting is done.
Program Setting
Press
to enter program setting mode.
Comfort
Time Slot
i) Press
or
to select weekday for assigning a program. Press
to confirm. The program number will be flashing.
ii) Press
or
to select the program number.
P0 – P7 are the default programs and P8 – P15 are the editable programs.
Press
to confirm.
iii) If P0 – P7 has been selected, the program assignment for the selected
weekday is finished. If P8-P15 is selected, the time slot at the top will be
flashing.
Press
or
to locate the cursor. Press
Press
to assign Comfort time slot and
Press
Press
Internal Setting
Hold
Press
or
the setting.
System Mode:
HE – Heat mode (default value)
CL – Cool mode
Display Unit:
12 – 12 hour display unit (default value)
24 – 24 hour display unit
to confirm.
Minimum Off Delay:
Sd – Short delay (default value)
to confirm.
Ld – Long delay (5 min)
*Only affects Heat mode.
Temperature Calibration:
-3, -2.5, -2, -1.5, -1, -0.5,
0 (default value), 0.5 , 1, 1.5, 2, 2.5,
3°C
RF Address
00000000 – 11111111
(256 combinations)
Econ
Time Slot
11111111(default value)
RF Address Matching
Example:
Temperature Setting for Current Mode
Simply press
or
to adjust the setting temperature. The temperature will be saved for
to confirm.
the current operation mode. (Comfort / Econ / Override)
for Econ time slot.
to confirm.
for exit after the setting is finished.
and
key to enter internal setting.
to switch between different items and press
or
once, the setting temperature will be flashing. Press
Comfort Temperature Setting
Hold
until the temperature is flashing.
Press
or
to adjust the setting temperature.
The temperature will be saved for the Comfort mode
to start
Econ Temperature Setting
Hold
until the temperature is flashing.
Press
or
to adjust the setting temperature.
The temperature will be saved for the Econ mode
Specification
Frequency:
Temperature Measurement:
Accuracy:
Temperature Controllable Range:
Heat:
Comfortable Mode:
Economic Mode:
Override Mode:
Cool:
Comfortable Mode:
Economic Mode:
Override Mode:
Resolution:
Power Supply:
Operating Temperature:
Storage Temperature:
Sensing Element:
Receiver Output Rating:
TEMPER ENERGY INTERNATIONAL S.L.
Polígono industrial de Granda, nave 18
33199 • Granda - Siero • Asturias
Teléfono: (+34) 902 201 292
Fax: (+34) 902 201 303
Email: info@grupotemper.com
www.grupotemper.com
868Mhz
0C~40C
±0.5C
7C~35C
5C~33C
5C~35C
5C~33C
7C~35C
5C~35C
0.5C
2 x AAA alkaline batteries
0°C~50°C
-5°C~50°C
NTC thermistor
230VAC 16A (max.)
140910