Specification; Function - koban KLD1 MW Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Welcome to use KLD1 MW Microwave LED Sensor Lamp!
The product adopts microwave LED sensor mould with high-frequency electro-magnetic wave
(5.8GHz) and integrated circuit, SMD LED. It gathers automatism, convenience, safety,
saving-energy and practical functions. The wide detection field is consisting of detectors. It works
by receiving human motion. When one enters the detection field, it can start the load at once and
identify automatically day and night. Its installation is very convenient and its application is very
wide. Detection is possible to go through doors, panes of glass or thin walls.

SPECIFICATION:

Power Sourcing: 220 -240V/AC
Power Frequency: 50/60Hz
Ambient Light: <3-2000LUX (adjustable)
Time Delay: Min. 10sec±3sec
Max. 12min±1min
Rated Load: 21W (1600LM)
Stand-by Period: 0s, 90s, 5min, 10min,
30min, +∞(choice)
Power Consumption: approx 0.9W

FUNCTION:

--Can identify day and night: It can work in the daytime and at night when it is adjusted
to the "sun" position (max). It can work in the ambient light less than 3LUX when it is
adjusted to the "3" position (min). As for the adjustment pattern, please refer to the
testing pattern.
--SENS adjustable: It can be adjusted according to using location; the detection distance
of low sensitivity could be only 4m and high sensitivity could be 16m which fits for
large room.
--Time-Delay is added continually: When it receives the second induction signals within
the first induction, it will restart to time from the moment.
--Time–Delay is adjustable. It can be set according to the consumer's desire. The
minimum time is 10sec. The maximum is 12min.
--It offers 3 levels of light: 100 %--> dimmed light (20% optional) -->off; and 2 periods
of selectable waiting time, motion hold time and stand-by period; selectable LUX value
and choice of detection area.
With ambient light more
than daylight threshold,
the lamp does not switch
on when someone
enters the room
www.grupotemper.com
Detection Range: 180°/360°
Detection Distance: wall: 5-15m (adjustable)
HF System: 5.8GHz CW radar, ISM band
Installing Height: wall: 1.5-3.5m
Stand-by Dimming Level: 20%
Transmission Power: <0.2mW
Detection Motion Speed: 0.6-1.5m/s
With ambient light less
than daylight threshold,
the lamp will be on
100% when someone
enters the room
Microwave LED Sensor Lamp
ceiling: 2-8m (radius), adjustable
ceiling: 2-4m
People left, light dims
to 20% (optional)
stand-by level after
hold time
KLD1 MW
Light switches off
automatically after the
stand-by period elapsed
13

Publicidad

Tabla de contenido
loading

Tabla de contenido