Installation; Connection-Wire Diagram; Test - koban KLD1 MW Manual De Instrucciones

KLD1 MW
Microwave LED Sensor Lamp
NOTE: the high-frequency output of the HF sensor
is <0.2Mw- that is just one 5000th of the transmission
power of a mobile phone or the output of a microwave
oven, the baby can't touch it
SENSOR INFORMATION:
Height of installation: 2-4m
INSTALLATION: (see the diagram)
--Switch off the power.
--Unload the plastic cover anti-clockwise to open it.
--Put the wire through the wire holes with rubber band which is at the bottom pan of light, and
connect the wire with terminal according to connection-wire diagram.
--Fix the base on the ceiling through the holes on the bottom pan with enclosed inflated screws
--Switch on the power and test it.
CONNECTION-WIRE DIAGRAM：

TEST:

--Turn the LUX knob clockwise on the
maximum (sun). Turn the SENS knob clockwise
on the maximum (+). Turn the TIME knob
anti-clockwise on the minimum (10S),
--When you switch on the power, the lamp will be on at once. And 10sec±3sec later the lamp
will be off automatically. Then if the sensor receives induction signal again, it can work normally.
14
Detection Distance: Max.8m
www.grupotemper.com