Ideal SpliceLine 42 Instrucciones De Instalación

Installation Instructions - SpliceLine Wire Connectors
Model 42
• Do not exceed the rating of these connectors.
• Turn OFF power before removing or installing connectors.
• Wiring must comply with all applicable electrical regulations.
• COPPER TO COPPER ONLY. Do not use on aluminium wire.
• Incorrect use of these connectors can cause electrical fires, personal injury or death.
• These connectors are suitable for solid and semi-rigid (<7 strands) conductors.
They are not suitable or rated for use with flexible cable with >7 strands.
• Strip wires back 13mm.
• Grip wire firmly and push conductor into open port.
• Use only one conductor per port.
• Connectors are reusable on solid wires of the same wire gauge or larger. If reusing connectors,
cut and re-strip conductors
• In order to remove a wire, pull and twist the wire back and forth.
• DO NOT RE-USE connector on stranded wire.
Strip Length
13mm
Model Colour
42 Orange
* Stranded wire is limited to ≤ 7 strands
Insertion Removal
Rating
32A / 450V /105°C
www.wire-connectors.com / www.idealindustries.co.uk
Removal
Wire Range
Solid: 0.5mm - 4.0mm
2 2
Stranded*: 1.0mm - 2.5mm
2 2
Test
1/5