Zycoo SC15 Guía De Instalación Rápida página 8

2. Cut a hole in the ceiling with 210±5 mm diameter.
3.Connect network cable and power supply (if PoE is not enabled on the network cable), and other cabling if required.
4.Detach the metal mesh (adsorbed by magnets).
5.Place the mounting bracket on top of ceiling, push the speaker back end into the ceiling through the mounting
bracket ring and ensure the mounting bracket is tightly attached to the ceiling.
6.Adjust the clips for being able to clamp with the mounting bracket.
7.Tighten the screws of the 4 clips in order to tighten the clamping of the clips with the mounting bracket and the
ceiling, and then cover the metal mesh.
Bracket
φ220mm
Metal Mesh
Bracket
Ceiling
Web Login
1.Connect network cable and power supply (if PoE is not enabled on the network cable).
2.Wait for 30 seconds then press and hold the RST button for 5 seconds and release, it will announce the IP address
obtained from the DHCP server. If there's no DHCP server or DHCP fails, it will use default IP 192.168.1.101. In the
browser address bar input the IP address you hear to open its web management interface. Default username and
password admin/admin.
06