Zycoo SW15 Guía De Instalación Rápida página 7

English
Installation
1. Use an 8 mm drill to drill 2 mounting holes with 58 mm vertical spacing.
2. Insert a plastic anchor into each of the mounting holes and use a rubber hammer to tighten the installation of the anchors.
3. Separate the mounting bracket, and install part A to the mounting holes using the M5*45 screws, as shown in Figure1. If the
mounting surface is a plate, then tighten the M5*45 screws using the bolts, as shown in Figure 2.
Plate
Wall
A A
Figure 1 Figure 2
4.Install the part B of the mounting bracket to the rear panel of the SW15 speaker, use KA5*20 screws to fix it. See below
instructions for vertical or transverse installation.
B
B
Vertical Installation Transverse Installation
05