Important Information
FOLLOW THESE
ENG
INSTRUCTIONS
CAREFULLY AND
KEEP THEM FOR
FUTURE
REFERENCE
!
WARNING
•
Intended for use with children from 6
months through 24 months.
•
To prevent serious injury or death,
securely install gate or enclosure and use
according to manufacturer's instructions.
•
Never use with a child able to climb over or
dislodge/open the gate or enclosure.
•
Never use if gate is less than 3/4 of
child's height.
•
Do not use if any part of the PlayDen is
broken or missing.
•
Discontinue use if any part of PlayDen is
damaged.
Maintenance
•
No part of PlayDen requires lubrication.
•
Clean PlayDen using warm, soapy water
or a damp cloth.
•
Do not use abrasive cleaners or bleach on
PlayDen or pad fabric.
Unpacking
1. Unpack your folded PlayDen on a stable
surface, making sure handle is on top. Each
corner is connected by plastic, interlocking
hinges.
2. How to adjust the sections:
A spring is fitted in all cones that deliberately
creates tension when adjusting.
2
This PlayDen® is designed for children from 6
months to 24 months. Since each child's
skills develop at different ages, these parameters
should be monitored against your child's own
development.
Before attempting to unfold the PlayDen, read
instructions thoroughly. Failure to do so may result
in damage to the PlayDen or injury to your child.
Your PlayDen is completely assembled and
folded compactly, and must be unfolded in
sequence.
Unpack your PlayDen on a stable surface.
•
When folded, store away from children.
•
This product will not necessarily prevent
all accidents. Never leave child
unattended.
•
Use only spare parts available from
KidCo.
•
Never allow child to climb or swing on
PlayDen or walk through door.
•
Use only with the locking/latching
mechanism securely engaged.
•
Never climb over the PlayDen.
•
Never hang or tie toys etc. to any part
of the gate.
•
Fabric may be washed on gentle cycle in
warm water and air dried. Never tumble
dry. Wash before use.
•
If using out doors, and to help prevent
rust, treat PlayDen with a rust inhibitor.
Some rusting may still occur.
At corner, lift up slightly on section with hinge
teeth facing down (2.1) while gently pressing
down on connected section (2.2). Rotate
sections to desired position (2.3). Release to
lock into place.
Note: Each hinge adjusts from 0˚ to 270˚ in 10˚
increments.