Celestron 47007 Manual De Usuario página 3

•
Alarm Setting – push and the "MODE" button to enter the alarm mode. Press and hold the
"MODE" button a few seconds and then set the hour and minute of the alarm using the "+" and
"-"buttons and confirm the data by pressing the "MODE" button. Press "MODE" to show the
alarm time and the "AL." icon will be displayed briefly and then press the "AL" to have a bell
appear (in the clock display area) meaning that the alarm is enabled. To turn the alarm off
(disable) press "AL" again and the bell icon will disappear. To stop the alarm press the "+" or "-
" or "AL".
•
Channel – if your Sensor is set correctly to Channel 1, you will have the LCD display for the
outdoor temperature and humidity. If you do not have an outdoor temperature and humidity
display, push and hold the "SEARCH" button until you hear a beep and the display should show
up in a few seconds.
•
Placement – the Receiver can be put on a table, desk, or other flat surface or it can (by using a
hanger cut out on the rear of the Receiver) be hung on a wall or other location.
•
Reset – if for some reason the LCD display does not function properly and you are using new
batteries, use a pin (or other very small object) to press the "RESET" button on the rear of the
Receiver.
Specifications:
•
Indoor Temperature Range = 0º to +50º C ( + 32º to + 122º F)
•
Remote Sensor Temperature Range = -20º to + 70º C ( -4º to + 158º F)
•
Indoor/Outdoor Humidity Range = 20% to 95% Relative Humidity
•
Resolution = ± .5º C ( ± 1.5º F) for temperature & ± 1.5% humidity
•
Clock = digital quartz
•
Transmission = RF433 MHz
•
Dimensions = Receiver – 8.3" x 3.0" x 10.3" (211mmx76mmx262mm) Sensor - 2.4" x 1.1" x
3.8" (61mmx28mmx97mm)
•
Weight = Receiver - 25oz/709g Sensor - 3oz/85g
2835 Columbia St.
Torrance, California 90503 U.S.A.
www.celestron.com
Printed in China 0110
All manuals and user guides at all-guides.com
RoHS