Software Install; Operating Procedure - Shimano SWAN-1 Manual Del Usuario

SWAN-1

Software install

1. USB Driver
Connect EVB and PC by USB cable.
Run USBXpressInstaller.exe in "USB Board Drivers" folder
2. ANTware
Run ANTwareII_v3.0.11.msi.

Operating procedure

1. Continuous transmission
a. Connect EVB and PC by USB cable. Run ANTware. Click and open right window.
b. Click "General" tab and uncheck "Increment last byte every message".
c. Click "Broadcast" tab. Type in "1ba84b3e1ba84b3e" and click "Set Broadcast".
d. Set frequency and click "Set Radio Frequency".
e. Type in "256" instead of 8192 and click "Set Channel Period"
f. Click "Auto-Open"
SHIMANO INC.
8 May 2012 Rev.E
SHIMANO INC. Confidential
4/11