Note:
1. When using the force start function, the short circuit protection will be
disabled. Make sure that the black clamp and the red clamp are
connected correctly before using this function.
2. After using the force start function, if you are still unable to turn on the
engine, the vehicle battery may be damaged. Please replace the vehicle
battery.
How to use the force start function:
Use the small pin (included in the package) to press and hold the force
start button on the battery clamps for 3 seconds. The indicator light would
turn green. Within 30 seconds, you need to start your car. The indicator
light would turn red if started correctly
Beep,Beep
After connecting the battery
clamp to the vehicle battery
correctly, the green light and
red light are flashing
alternatively
If you have checked that the battery
clamp is connected to the vehicle
battery correctly, but the green light
and red light are flashing
alternatively, please use the force
start function.
The battery clamp is connect-
ed correctly, but the red light
is still on with buzzing
If you have checked that the
connectio n is right, but the red light
is still on with buzzing.
(1) Adjust your clamp for maximum
contact for both sides of the clamp.
(2) If solution (1) does not work,
please use the force start function.
EN-6