Suaoki U18 Manual Del Usuario página 6

• If the red and green indicator lights keep flashing alternately (the buzzer may
beep), you need to use force start function (check 'Force Start Function'
section for more details).
• If the red indicator light stays on and the buzzer beeps, you need to use force
start function (check 'Force Start Function' section for more details).
3.Once the green indicator light is on, you need to start your car within 30
seconds.
4.After your car is started successfully, you need to disconnect the clamps from
the car battery immediately.
5.Disconnect the EC5 plug of battery clamp from the jump starting port.
Force Start Function
※Note: Short circuit protection will be disabled when using the force start
function. Make sure that the black clamp and the red clamp are connected
correctly before using this mode.
When to use force start function?
1.Use force start function when the voltage of the car battery is lower than 1V, that
is, when the car battery is severely damaged.
2.Use force start function when you jump start your car with the car battery
removed.
EN-4