Storage And Maintenance - Suaoki S670 Manual Del Usuario

Charge via a Car Charger
It's a good choice to charge the product via a car charger when you drive all the way. Plug one end of the
car charger to your portable power station, and then plug the other end to car cigarette socket of your car.
You could check the charging state from the LCD screen.
Note: To charge the portable power supply with car charger, you need to start your car first.
How to Charge Your Electronic Devices
Step 1: Turn on the product
Press and hold the main power button for 2 seconds to turn on the product. The corresponding indicator
light and the LCD screen would be on.
Step 2: Turn on AC/USB/DC output
Press and hold the AC/USB/DC power button for 2 seconds to turn on the AC/USB/DC output. The
corresponding indicator light would be on and the LCD screen would show 'AC ON'/'DC ON'.
Note: When not using certain ports, make sure to turn off the output to conserve power.
Step 3: Charge your electronic device
Connect your device to the power station. The LCD screen will indicate if the power station is charging your
devices. The number on the LCD screen represents the charging power providing to your devices.
Step 4: Turn off AC//USB/DC Output
Press and hold the AC/USB/DC power button for 2 seconds to shut down the AC output/USB output/DC
output. The LCD screen will show AC OFF/DC OFF.
Step 5: Turn off the portable power supply
Turn off manually:
Press and hold the main power button for 2 seconds to turn off the main power supply. Hold the button
until the LCD screen lights off. Release the button and the indicator light would be off.
Turn off automatically:
When the product is turned on while the AC//USB/DC power output are off, the main power supply will
shut down automatically in 1 minute of inactivity. The portable power supply will shut itself down when the
battery capacity is lower than 10%.
Note:
1. When not using the product, please turn off the product in time.
2. Please fully charge the product before storing it away for a long time.
How to Use the LED Flashlight
Press and hold the LED Flashlight Button for 2 seconds to turn on the LED flashlight. Press and hold the
LED Flashlight Button again for 2 seconds to turn off the LED flashlight.
EN-05
Note:
1. Some products with instantaneous high current may trigger the overcurrent protection of the 13V/10A
Cigarette Lighter Socket and DC 12V/10A Output Port (5521).
2. Please make sure that the connected Electronic Devices can work normally before using this product.
3. The power of the AC output is below 500W.
4. Although the rated power of some electronic devices are below 500W, they may not be compatible with
this product (such as air conditioners, motors, etc., which require instantaneous high current).
5. The output will automatically stop if the overload protection is triggered.
6. If the connected Electronic Devices are not strong in anti-interference ability, it may cause frequency
interference. For example, noise occurs in broadcast, video player, TV, etc.
Intelligent Cooling
The fan cooling will automatically start for any of the following conditions:
1. The load of AC Output Port is higher than 200W.
2. The load of DC 12V/10A Output Port (5521) is higher than 80W.
3. The load of 13V/10A Car Charger Socket is higher than 80W.
4. When using the 168W PV charging, the fan will not rotate. When the heatsink temperature is higher than
60°C or the battery pack temperature is higher than 46°C, the fan cooling will automatically start.
5. After trigger the over-temperature protection on the high-power load, this product will dissipate heat as
soon as possible. When the PV is plugged in, the fan cooling will automatically start whether it is charged
or not. Note: Do not use the product when the fan cannot work.

Storage and Maintenance

1. Please fully charge the battery before storing the product.
2. Please turn off all power buttons after use.
3. When cleaning the product, please wipe the product with a dry cloth.
4. Do not use gasoline, volatile oil, thinner or kerosene to clean the product.
5. Do not store this product in humid, high-temperature, hypersaline, dusty, or strong magnetic field
environments for a long time.
6. Do not drop this product or store it in a bumpy environment for a long time.
7. Do not use hard or sharp objects to hit this product.
8. Do not connect this product to appliances that exceed the rated power of the product.
9. Do not leave this product with low battery for a long time.
10. Do not leave this product at full load for a long time.
11. Do not discharge this product while charging.
12. Please handle gently when using this product.
13. Please plug the plugs into the interfaces in vertically, do not shake up and down.
14. Do not expose the product to direct sunlight for a long time.
15. Do not let any liquid enter the product.
16. Running a discharge/charge cycle is recommended at least once every three months. (Fully discharge
the product and come with a subsequent recharge.)
17. Please avoid overcharge and over-discharge.
18. It is recommended to recharge the product in time when the battery is low.
EN-06