Beper P304CAP001 Manual Del Usuario página 9

Cleaning and maintenance
The product must be cleaned immediately after each use.
Always turn off the product and make sure that the battery charger is disconnected before starting
any cleaning operation.
Do not use compressed air, abrasive cleaners, wipes or aggressive liquids such as gasoline, al-
cohol, bleach or acetone to clean the appliance.
Do not clean, remove, or replace the shaving head while the product being switched on.
Do not apply any pressure on the shaving head.
Use only the supplied cleaning brush. Any other brush can cause damage.
Apply few drops of the supplied oil to keep the blade lubricated.
Replace the shaving head Fig. C-D
If the shaving head is damaged, it is recommended not to use the product and immediately replace it.
Caution: When handling the shaving head, be careful because it is sharp and you may
be injured.
To remove the shaving head, unscrew the two screws located on the shaving head itself using
a screwdriver, with your free hand it is advisable to support the shaving head to prevent it from
falling. (Fig. C)
Replace the damaged head with the new one, aligning the shaving head with its holder, replace the
two screws and tighten them with the screwdriver.
Before storing the product make sure it is clean and dry.
Technical data
Lithium battery 14500 600mAh
Power supply: 5VDC ­­­­ 1A
For any improvement reasons, Beper reserves the right to modify or improve the product
without any prior notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed of in the
normal unsorted municipal waste stream.
Old appliances must be collected separately in order to optimize the recovery and recycling of the
materials they contain, and reduce the impact on human health and the environment. The crossed
out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of
the appliance, it must be separately collected.
9
EN