Beper BB.210 Manual Del Usuario página 11

Milk Frother Use instructions
Operation and instructions for use
Place the base on a flat, non-slip surface.
Place the chosen accessory on the base of the container.
Pour the milk paying attention to the MIN, MAX levels and only if I intend to froth the milk, MAX
inside the container.
Attention: for best results it is recommended to use whole milk. The foam will not have the same
result if soy milk or lactose-free milk is used.
Place the lid
Connect the product to the electrical outlet.
Press one of the two keys on the container like this:
Functions
To mix and/or froth the hot milk
To froth cold milk
The function is used to froth the cold milk the led blue light will switch on while press it, and will turn off
automatically when the operation is fully completed.
The function with the plastic mixing accessory is only used to heat milk, make hot chocolate (only with
chocolate powder not with chocolate pieces). While with the accessory to make frothing in addition to heating
the milk, it will froth when hot. With this function, when the button is pressed, the red light will turn on, and will to
turn off when the operation is fully completed.
You can stop the operation at any time by pressing the selected button a second time.
If the product is accidentally turned on empty, thanks to its overheating protection system, the product will turn
off automatically after 30 seconds.
Cleaning
Always unplug the appliance before cleaning.
Allow the appliance to cool down.
It is recommended to clean the product immediately after use and always before storing it.
Never immerse the base in water during cleaning.
Do not use a wire brush or other abrasive objects.
Never use aggressive or abrasive detergents.
Surface of the base
Clean the external surface of the base with a damp cloth, without using cleaning agents.
The accessories and the lid can be washed by hand with slightly soapy hot water and a soft cloth.
Note: To remove the mixing accessories, pull them upwards.
Technical data
Power: 450-550 W
Power supply: 220-240V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
11
EN
shown